SPD-CT811B9-V2 Installation and Wiring

Rated Voltage	24 Volts
Rated For Motors	Up To 350 Watts
Maximum Current	30 Amps
Rated For Chargers	Up To 3 Amps
Conversion Efficiency	95%
Under Voltage Protection	20.5 Volts
Recommended Fuse Size	30 Amps
Dimensions	3-3/4" Long x 2" Wide x 1-1/2" High

Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 20.5 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor.

*Power Connector Red = Positive Black = Negative Mating Connector Item # CNX-50	Required Connection
Motor Connector Red = Positive Blue = Negative Mating Connector Item # CNX-50	Required Connection
Throttle & Brake Lever Switch Connector Throttle = Red, Black, Green Brake Lever = Red, Black Battery Gauge = + Gray, - Black Mating Connector: CNX-54	Throttle = Required Connection ~Brake Switch = Optional Connection ~Battery Gauge = Optional Connection
Key Switch Connector Mating Connector Item # CNX-51	Required Connection
Battery Charger Connector Red = Positive Black = Negative Mating Connector Item # CNX-51	~Optional Connection
Power Light Connector Mating Connector Item # CNX-52	~Optional Connection
Brake Light Connector Mating Connector Item # CNX-51	~Optional Connection

*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.