Speed Controller SPD-CT312C1 Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 650 Watts
Maximum Current   30 Amps
Rated For Chargers   Up To 3 Amps
Conversion Efficiency   95%
Under Voltage Protection   31.5 Volts
Recommended Fuse Size   35 Amps
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 31.5 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor.
*Power Connector
Thick Red = Positive

Thin Red = Positive
Black = Negative

Mating Connector
Item # CNX-52


Required Connection
Motor Connector
Yellow = Positive
Blue = Negative

Mating Connector
Item # CNX-50
Replaces previous controller versions with brown and blue wires.

Required Connection  
Throttle/Battery Indicator Connector
Throttle = Red, Black, Blue
Battery Gauge = Orange, Black

Mating Connector
Item # CNX-53
Replaces previous controller versions with black, red, gray, and green wires.

Throttle is a Required Connection
~Battery Gauge is an Optional Connection
Battery Charger Port Connector
Red = Positive
Black = Negative

Mating Connector
Item # CNX-51

~Optional Connection
Brake Lever Switch Connector 1

Mating Connector
Item # CNX-51
Replaces previous controller versions with red and black wires.

~Optional Connection
Brake Lever Switch Connector 2


Mating Connector
Item # CNX-51

Replaces previous controller versions with red and black wires.

~Optional Connection
*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.