Speed Controller SPD-481000E Installation and Wiring

Rated Voltage   48 Volts
Rated For Motors   Up To 1000 Watts
Maximum Current   30 Amps
Conversion Efficiency   95%
Under Voltage Protection   41 Volts
Recommended Fuse/Circuit Breaker Size   40 Amps
Throttle   Hall Effect Throttle (Standard 3 Wire)
Dimensions   6-1/2" x 3-1/2" x 2"
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 41 Volts ± 1.0 Volts)
*Power Connector
Red = Positive
Black = Negative
12 Gauge Wire
Required Connection
Motor Connector
Red = Positive
Blue = Negative
12 Gauge Wire
Required Connection
**Throttle Connector
Red = + 5 Volts Output
Black = Negative
Green = 1-4 Volts Input
Mating Connector
Item # CNX-52
Required Connection
Brake Switch Connector
Black+Yellow Disconnected = Motor On
Black+Yellow Connected = Motor Off
Mating Connector
Item # CNX-51
Optional Connection
*The battery pack should be the last connection made.
*Fuse or circuit breaker protection and power switch or power relay are required to be installed between the speed controller and the battery pack.
*Power switch/relay and fuse/circuit breaker connects to the red wire between the speed controller and battery pack. The fuse/circuit breaker should be as close to the battery pack as possible.
*The two thick red wires are connected together inside of the controller so it does not matter which thick red wires go to the battery pack or motor.
**Requires standard 3-wire throttle to operate.