|
Speed Controller SPD-24500R Installation and Wiring |
|
| Rated Voltage | 24 Volts |
| Rated For Motors | Up To 500 Watts |
| Maximum Current | 30 Amps |
| Rated For Chargers | Up To 3 Amps |
| Conversion Efficiency | 95% |
| Under Voltage Protection | 20.5 Volts |
| Recommended Fuse Size | 40 Amps |
| Dimensions | 4-3/8" L x 2-5/8" W x 1-5/8" H |
| Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 20.5 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. |
|
*Power Connector |
|
| Motor
Connector Blue = Positive White = Negative Mating Connector Item # CNX-50 |
 Required Connection |
| Throttle
Connector Mating Connector Item # CNX-52 |
 Required Connection |
| Key
and Forward/Reverse Switch Connector Mating Connector Item # CNX-52 |
 Connect Red+Yellow wires for power on in forward. Connect Red+Yellow+Blue wires for power on in reverse. Required Connection |
|
Battery Charger Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
| Brake
Lever
Switch Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
| Brake
Light Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
| Power
Light Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
|
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |